Cooper Menvier SD3 Manuel de l'opérateur télécharger pdf (Page 26)

Long play:

If enabled (ON) the recordable messages have a maximum record time of

30 seconds.

If disabled (OFF) the recordable messages have a maximum record time of

15 seconds; also the speech is of a higher quality, (default).

Line Fault:

If enabled (ON) the SD2 logs any line fault and displays ‘line fault’ on the

display; it also produces an audible tone every 60 seconds. Entering

programming mode will silence the audible tone if the line fault persists.

If Disabled (OFF) the SD2 logs any line fault, (default).

Access Codes

The SD2 is protected by a 4-digit passcode; the passcode is required to

gain access to the programming menus. The operator’s passcode is also

used for aborting calls. The default operator’s access code is “1234”.

To change the operator’s passcode:

From the main menu press ¬and ¦

or 4 to select the change access

codes:

1. Press [ to select:

2. Press [ to select:

3. Enter new passcode, e.g. 2580:

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 55 56

Pas de commentaire

Cooper Menvier SD3 Manuel de l'opérateur Page 26